Its not exactly an upgrade script - it makes a backup of the complete
system and then sends it as a tarball to a remote (non-cca) box. You
then do a clean install of the CAMs and CASs and restore the tarball...

Jeff 

-----Original Message-----
From: Perfigo SecureSmart and CleanMachines Discussion List
[mailto:[log in to unmask]] On Behalf Of Lanstein, Alex C
Sent: Tuesday, June 06, 2006 10:56 AM
To: [log in to unmask]
Subject: Re: [PERFIGO] Upgrade 3.5.8 to 3.6.2 script doesn't run

They have an upgrade script?  My understanding was that if you were
moving to 3.6.x you needed to format and do a fresh install
 
Regards,
Alex Lanstein
 

________________________________

From: Perfigo SecureSmart and CleanMachines Discussion List on behalf of
Hague, Jeff
Sent: Tue 6/6/2006 10:43 AM
To: [log in to unmask]
Subject: Upgrade 3.5.8 to 3.6.2 script doesn't run



Hi all!
I am trying to do an upgrade from 3.5.8 to 3.6.2 per Cisco's recommended
procedure. I have copied the upgrade tarball to the Cam's /store
directory, untarballed it, switched to the upgrade directory and run the
command > ./UPGRADE-3.6.2.pl but nothing happens - it just drops me back
to the prompt. The directions say I will see a banner and the system
backup will begin, but that doesn't seem to be happening. I am not a
Linux type so I don't know what steps to take to determine what is (or
isnt) happening. Any ideas?
Thanks!

Jeff