Make sure the "Vulnerable if ..." setting is not set to "NEVER". The
setting is at Clean Access -> Network Scanner -> Scan Setup ->
Vulnerabilities.
Dennis Xu
Network Analyst(CCS)
University of Guelph
5198244120 x 56217
-----Original Message-----
From: Cisco Clean Access Users and Administrators
[mailto:[log in to unmask]] On Behalf Of Andrew Gehring
Sent: May-30-07 5:57 PM
To: [log in to unmask]
Subject: Network Scanner V4.1.1
Has anyone successfully used the network scanner on 4.1.1 against a OS X
system?
I wrote a simple nasl that always reports a "HOLE", but the scanner
doesn't
seem to actually run.
Using the Test under the NS, reports back HOLE. but I am allowed to
connect
to the network anyway.
Ideas?
Thanks,
Andrew