OK, I have had this problem for awhile, and I finally decided to post about it. I Connect to the VAX at 14.4, 8-bit so I can use Z-modem protocol. I get about 1500-1600 bps with flow/error control, but after 150k of data has been downloaded, I get errors, everything freezes and I have to disconnect. Later, I was told that this was due to the GANDALF data switch, and not the VAX. I was under the impression that at 14.4, data transfers to your home computer are faster than GANDALF can get the data from the VAX due to the increased user load. Therefore, once the 150k buffer on GANDALF is depleated, everything locks up. Is this the correct hypothesis into the situation? Has anybody else noticed this? One fact of note, if I connect at a lower rate, like 9600, I get no errors during dowload. Any suggestions or comments? -Dan Hunter [log in to unmask]